F. N. CUTHBERT, INC.
800-472-3292
  

Baseboard Heater Store


Your Source For Electric Baseboard Heaters

Heater Selection Guide
Residential Heaters
Commercial Heaters
Portable Heaters
Thermostats & Accessories
Danfoss Heating Systems
Solaira Infrared Heaters
Gas / Propane Heaters
More Electric Heaters
Heat Loss Calculator
King Electric
Cadet
Dimplex
Hearthrite
Honeywell Aube
Mr. Heater
Qmark / Marley
Williams
Home>More Electric Heaters

Qmark / Marley QTS1104 Fan Forced Toe Space Heater - 240 Volts - 1100 Watts

Part Number QTS1104
review 0 Review(s)
0
 Qmark / Marley QTS1104 Fan Forced Toe Space Heater - 240 Volts - 1100 Watts
QTS Series Kickspace Heater
Review this item Review this item
Price
Retail Price:
$392.00
Your Savings:
$223.05
Your Price:
$168.95
Quantity

Qmark Fan Forced Toe Space Heater

Qmark QTS1104

Fan Forced Toe Space Heater

208/240 Volts - 826/1100 Watts - 3.97/4.58 Amps
 
2818/3752 Btus
 
Other Wattage and Voltage and voltage choices can be
found on our www.electricheaterwarehouse.com website
 
Fits Where No Other Heater Will
 
Multiple Wattage - Three Piece Construction
 
Built In Thermostat
 
 
Five Year Warranty
Can be recessed into toe space areas under kitchen or utility room cabinets or into the soffit area above them. It can also be recessed into the risers of a stairway or under the vanity in the bathroom. It is convenient for checkout counters, ticket or tollbooths and many other places where no other heater seems to fit.
 
  • Quick disconnects on wiring leads permit convenient means of changing outputs

 

  • Small Size - Back box is 14 1/8" wide x 8 7/8" deep x 3 1/2" high (will fit in the most narrow of applications.)  Front grille is 15 3/8" wide x 3 5/8" high

 

  • Over Temperature Protection - Comes equipped with an automatic over temperature protector that guards against overheating. Also standard is a pilot light that indicates the protector has operated. A thermal fuse provides a second level of over-temperature protection

 

  • Uniform Heating Of All Discharge Air - Heavy gauge steel fins are brazed to low watt density steel sheathed tubular heating elements in a uniform grid pattern. The grid covers the entire discharge area, resulting in uniform heating of all discharge air, lower operating temperature and prolonged element life

 

  • Quiet Operation The tangential blower and the impedance protected, permanently lubricated motor provide trouble free, quiet operation.

 

  • Three Piece Construction - A separate back box, fan deck and front cover make installation simple and quick. The slide in fan deck locks into place without the use of fasteners, cutting down on installation time.

 

  • Thermostat Options - The QTS1100 and QTS1104 Series units can be operated by either a built-in or remote wall mounted, double pole line voltage thermostat (M602W or WR-66). Model QTS1500T and QTS1504T are provided with factory installed thermostats and do not require a wall mounted thermostat.

 

  • Four Models Two models available for replacement installation where a wall thermostat was used and only two power wires were run into the old unit. These units are available in 120 volt or 240  /208 volt applications. Two other models with factory installed thermostats are available where higher wattage is required.

 

  • MOUNTING LIMITATIONS - Do not install heater behind towel rack, behind door, in floor, in closet, in ceiling, or where air flow may be obstructed. Thermostat range 45 to 85 F 

  • Multiple Wattages; Four Models

  • Steel Plate Fin Element; Built-In Thermostat

  • Thermal Cutout; Quiet, Tangential  blower

  •  3 1/2" High x 8 7/8" Deep x 14 1/8" Wide

  • 1100 watts at 240 volts

  • 5 Year Warranty On Element